The following Professional A/V products are compatible with Bitfocus Companion.
We do not directly support this software, all Roland modules are created and managed by the Companion community.
Additional tips for specific modules and models are located below this chart.
| Product |
Ports |
Module Available | TSP Serial Module Required |
| M200i | Yes | Yes | |
| M300 | Yes | Yes | |
| M-380 | Yes | Yes | |
| M-400 | Yes | Yes | |
| M-480 | Yes | Yes | |
| M-5000 | Yes | No | |
| M-5000C | Yes, Use M-5000 Module | No | |
| P-20HD | LAN, RS-232 | Yes | No |
| SR-20HD | LAN | No, Command Set Pending | No |
| V-02HD | Not Compatible | Not Compatible | |
| V-02HD MK II | Not Compatible | Not Compatible | |
| V-1HD | Not Compatible | Not Compatible | |
| V-1HD+ | RS-232 | No, Use Generic TCP Module | Yes |
| V-1SDI | RS-232 | No, Use Generic TCP Module | Yes |
| V-4EX | Not Compatible | Not Compatible | |
| V-60HD | LAN, RS-232 | Yes | No |
| V-160HD | LAN, RS-232 | Yes, Beta Only | No |
| V-600UHD | LAN, RS-232 | Yes | No |
| V-800HD | RS-232 | No, Use Generic TCP Module | Yes |
| V-800HD MK II | RS-232 | No, Use Generic TCP Module | Yes |
| V-1200HD | LAN, RS-232 | Yes | No |
| VR-1HD | Not Compatible | Not Compatible | |
| VR-3EX | Not Compatible | Not Compatible | |
| VR-4HD | RS-232 | No, Use Generic TCP Module | Yes |
| VR-50HD | RS-232 | No, Use Generic TCP Module | Yes |
| VR-50HD MK II | LAN, RS-232 | Yes | No |
| VR-120HD | LAN, RS-232 | No, Command Set Pending | No |
| VP-42H | LAN, RS-232 | Yes | No |
| XS-1HD | RS-232 | No, Use Generic TCP Module | Yes |
| XS-42H | LAN, RS-232 | Yes | No |
| XS-62S | LAN, RS-232 | No, Use Generic TCP Module | No |
| XS-82H | LAN, RS-232 | No, Use XS-84H Module | No |
| XS-83H | LAN, RS-232 | No, Use XS-84H Module | No |
| XS-84H | LAN, RS-232 | Yes | No |
TSP Serial Module:
- You need to first set the target IP address of the Roland module or Generic TCP module to match the local IP of the computer on your network that is hosting the RS-232 serial connection.
P-20HD:
- Each command needs to start with "%02" and end with a LF return.
- Entering the Username and Password with the USR and PSS commands is required to enable control from the Generic TCP Module.